HomeLink Switch Test
In this manual: HomeLink Switch Test
~1min read
Test
1. Roof Console Module - Remove
2. HomeLink Switch - Test
NOTE: The HomeLink switch is built into the roof console module (A).
- Check for continuity between the terminals in each switch position according to the table.
NOTE:
- When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).


- If the result is not as specified, the HomeLink switch is faulty; replace the roof console module.
3. All Parts Removed - Install
- Install the parts in the reverse order of removal.
Was this page helpful?