Torque Converter Housing Selector Control Shaft Bearing Replacement
In this manual: Torque Converter Housing Selector Control Shaft Bearing Replacement
~1min read
Replacement
1. Selector Control Shaft Bearing - Remove

- Remove the selector control shaft bearing (A) using the 15 mm remover shaft, the 15 mm remover head, and the slide hammer.
2. Selector Control Shaft Bearing - Install

- Install the selector control shaft bearing until it bottoms using the 15 x 135L driver handle and the 32 x 35 mm bearing driver attachment.
Special Tool Required

- Bearing Driver Attachment, 32 x 35 mm 07746-0010100

- Driver Handle, 15 x 135L 07749-0010000

- Remover Shaft, 15 mm 07936-KC10100

- Remover Head, 15 mm 07936-KC10200

- Slide Hammer 07936-371020A
Was this page helpful?