Moonroof Drain Channel Slider and Cable Assembly Removal and Installation
In this manual: Moonroof Drain Channel Slider and Cable Assembly Removal and Installation
3steps
~18min
2/5difficulty
Done 0 of 3
Removal/Installation
NOTE: SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
1. Moonroof Motor - Remove
2. Drain Channel - Remove
3. Rear Middle Drain Tube - Remove
4. Moonroof Frame - Remove
5. Drain Channel Slider and Cable Assembly - Remove

- Remove the drain channel slider (A). (both side)

- Pivot the glass brackets (A) down by sliding the link lifters (B) back, and then slide both glass brackets back with the link lifters.

- Slide the moonroof link assembly (A) back, and then remove it from the frame (B).
6. All Removed Parts - Install
- Install the parts in the reverse order of removal.

Note these items:
- Apply multipurpose grease to the glass brackets (A) and the guide rail area of the frame (B) indicated by the arrows.
- Before reinstalling the motor, make sure both link lifters are parallel, and in the tilt up position.
7. Moonroof Glass Position - Adjust
8. Moonroof Control Unit - Reset
9. Water Leaks - Check
Was this page helpful?