Transmission Housing Differential Carrier Bearing Outer Race Replacement
In this manual: Transmission Housing Differential Carrier Bearing Outer Race Replacement
3steps
~18min
2/5difficulty
Done 0 of 3
Replacement
NOTE:
- Replace the carrier bearing with a new one whenever the bearing outer race is replaced.
- Adjust the preload after replacing the bearing and the outer race.
- Apply a light coat of clean ATF on all parts before installation.
- Unless otherwise indicated, illustrations used in the procedure are for AWD.
1. Differential Carrier Bearing Outer Race - Remove

- Remove the carrier bearing outer race (A), the spacer (B), and the 85 mm thrust shim (C) by heating the transmission housing to about 212 ΒΊF (100 ΒΊC) using a heat gun (D).
NOTE: Do not heat the transmission housing more than 212 ΒΊF (100 ΒΊC).
2. Differential Carrier Bearing Outer Race - Install

- Install the 85 mm thrust shim (A).
- Install the spacer (B) by aligning the tab (C) with the groove (D).
- Install the carrier bearing outer race (E).

Special Tool Required

- Driver Handle, 15 x 135L 07749-0010000

- Attachment, 83 mm 07HAD-SG00100
Was this page helpful?