Fuel Line Inspection
In this manual: Fuel Line Inspection
6steps
~36min
2/5difficulty
Done 0 of 6
Inspection
1. Fuel Line - Inspect
USA and Canada Models
- Check the fuel system lines and hoses for damage, leaks, and deterioration. Replace any damaged parts.
- Check all clamps, and make sure they are properly positioned and tightened.


Mexico Models
- Check the fuel system lines and hoses for damage, leaks, and deterioration. Replace any damaged parts.
- Check all clamps, and make sure they are properly positioned and tightened.



Fuel Leak Check
1. Intake Manifold and Intake Manifold Base - Remove
2. High Pressure Fuel Pump Cover - Remove

3. Fuel Rail Cover - Remove

4. Fuel Leak - Check

- Apply Red Check Spray to the joint of the injectors (A), the fuel rails (B), and the high pressure fuel pump (C). Set the probe of the leak detector (Snap-on Combustible Gas Leak Detector) on the joint.
- Install the intake manifold base and the intake manifold with original gaskets.
NOTE: The intake manifold base and the intake manifold gaskets will be replaced after the fuel leak check.
- Turn the vehicle to the ON mode, but do not start the engine. After the fuel pump runs for about 2 seconds, the low pressure fuel line will be pressurized. Repeat this two or three times, then check for fuel leakage.
- Start the engine. Hold the engine speed at 4,000 rpm for 1 minute, and stop the engine.
- Remove the intake manifold and the intake manifold base.
- Check for fuel leakage at the joint of the injectors, the fuel rails, and the high pressure fuel pump.
5. Fuel Rail Cover - Install

6. High Pressure Fuel Pump Cover - Install

7. Intake Manifold Base and Intake Manifold - Install
NOTE: Install the intake manifold base and the intake manifold with new gaskets.
Was this page helpful?