Camshaft Oil Seal Replacement In Car
In this manual: Camshaft Oil Seal Replacement In Car
4steps
~24min
2/5difficulty
Done 0 of 4
Replacement
1. Timing Belt - Remove
2. Camshaft Pulley and Back Cover - Remove
3. Camshaft Oil Seal - Remove
FRONT

REAR

4. Camshaft Oil Seal - Install
FRONT

- Clean and dry the camshaft oil seal housing.
- Apply a light coat of new engine oil to the lip of the camshaft oil seal.
- Using the ball joint remover/installer, a washer (A), and a 12 x 75 x 1.25 mm bolt (B), press in a new camshaft oil seal (C) squarely into the cylinder head to the specified installed height.
- Measure the distance between the cylinder head surface (E) and the camshaft oil seal (F).
Camshaft Oil Seal Installed Height
0.5-1.5 mm (0.020-0.059 in)
- Clean the excess oil off the camshaft, and check that the camshaft oil seal lip is not distorted.
REAR

5. Camshaft Pulley and Back Cover - Install
6. Timing Belt - Install
Special Tool Required

- Ball Joint Remover/Installer 07GAF-SD40330
Was this page helpful?