Ambient Light Removal, Installation, and Test
In this manual: Ambient Light Removal, Installation, and Test
~1min read
Removal/Installation
1. Roof Console Module - Remove
2. All Parts Removed - Install
- Install the parts in the reverse order of removal.
Test
1. Ambient Light - Test
NOTE: The ambient light is built into the roof console module (A).
- Check for continuity between the terminals in each switch position according to the table.
NOTE:
- When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).


- If the result is not as specified, the front ambient light is faulty; replace the roof console module.
Ambient Light Removal, Installation, and Test
Removal/Installation
1. Interior Light Switch - Remove
NOTE: The front ambient light is built into the interior light switch.
2. All Parts Removed - Install
- Install the parts in the reverse order of removal.
Test
1. Ambient Light - Test

NOTE: The ambient light is built into the interior light switch (A).
- Check for continuity between the terminals in each switch position according to the table.
NOTE:
- When an LED is located between terminals, check if the LED illuminates by connecting power and ground to the LED.
- Note this important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
- If the continuity is not as specified the interior light switch is faulty; replace the interior light switch.
Was this page helpful?