Idle Speed Inspection
In this manual: Idle Speed Inspection
3steps
~18min
2/5difficulty
Done 0 of 3
Inspection
NOTE:
- Before checking the idle speed, check these items:
- The malfunction indicator lamp (MIL) has not been reported on, and there are no DTCs.
- Spark plugs
- Air cleaner
- PCV system
- Apply the parking brake.
1. Evaporative Emission (EVAP) Canister Purge Valve Connector - Disconnect
2. HDS Connect
3. Idle Speed Inspect
- Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
- Check the idle speed under no load conditions: headlights, blower fan, radiator fan, audio system, and air conditioner off.
Idle speed should be: 680 +- 50 rpm (in P or N)
- Let the engine idle for 1 minute with high electric load (A/C on, temperature set to max cool, blower fan on high, headlights on high beam).
Idle speed should be: 680 +- 50 rpm (in P or N)
NOTE: If the idle speed is not within specification, do the PCM idle learn procedure. If the idle speed is still not within specification, go to the symptom troubleshooting.
4. Evaporative Emission (EVAP) Canister Purge Valve Connector Connect
Was this page helpful?