Tailgate Hinge Cover Removal and Installation
In this manual: Tailgate Hinge Cover Removal and Installation
4steps
~24min
2/5difficulty
Done 0 of 4
Removal
1. Tailgate Hinge Cover - Remove

- Release the retainer hooks (A) and the clip (B), and then remove the tailgate hinge cover (C).
2. Retainer - Remove

- Gradually separate the adhesive (A) under the retainers (B) while heating them with a heat gun to about 212―248ºF (100―120ºC).
NOTE:
- Do not overheat the painted surface around the retainers.
- To prevent the exterior plastic parts near heating surface from being overheated by a heat gun, wrap them with an aluminum foil.
Installation
1. Retainer - Install

- Clean the body bonding surface with a shop towel dampened with isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the clean surface.
- Apply the two-part epoxy adhesive (A) on the clip (B) as shown.

- Line up the retainer (A) with the alignment marks (B) on the body, and then press the adhesive portion (C) into place securely.
- Wait for adhesive to dry.
NOTE: Refer to the adhesive manufacturer's instructions in dry time.
2. Tailgate Hinge Cover - Install

- Install the tailgate hinge cover (A).
NOTE: Install the hooks (B) of the tailgate hinge cover to the retainer (C).
Was this page helpful?