Transmission Housing Idler Gear Shaft Bearing Replacement
In this manual: Transmission Housing Idler Gear Shaft Bearing Replacement
2steps
~12min
1/5difficulty
Done 0 of 2
Replacement
1. Idler Gear Shaft Bearing - Remove

- Heating the transmission housing to about 212 ºF (100 ºC) using a heat gun (A).
NOTE: Do not heat the transmission housing more than 212 ºF (100 ºC).

- Remove the idler gear shaft bearing (A) using the 22 mm bearing remover shaft, the remover handle, and the slide hammer.
2. Idler Gear Shaft Bearing - Install

- Install the idler gear shaft bearing until it bottoms using the 15 x 135L driver handle and the 37 x 40 mm bearing driver attachment.
Special Tool Required

- Bearing Driver Attachment, 37 x 40 mm 07746-0010200

- Driver Handle, 15 x 135L 07749-0010000

- Remover Handle 07936-3710100

- Slide Hammer 07936-371020A

- Bearing Remover Shaft Set, 22 mm 070MC-MFR0100
Was this page helpful?