Warm Up TWC Removal and Installation
In this manual: Warm Up TWC Removal and Installation
5steps
~30min
2/5difficulty
Done 0 of 5
Removal/Installation
Front Bank (Bank 2)
1. Front WU-TWC Bracket - Loosen

- Loosen or remove the front WU-TWC bracket mounting bolts (A).
- Remove the self-locking nuts (B).
2. Engine Cover - Remove
3. EGR Pipe A - Remove
4. Front A/F Sensor (Sensor 1) - Remove
5. A/C Condenser Fan Shroud Assembly - Remove
6. Front WU-TWC - Remove

- Carefully remove the front WU-TWC (A) assembly.
7. WU-TWC Covers - Remove

8. All Removed Parts - Install

- Install the parts in the reverse order of removal with new gaskets and new self-locking nuts.
NOTE:
- Before installing the WU-TWC, install the WU-TWC covers.
- Tighten the WU-TWC bracket mounting bolts in the numbered sequence shown.
Removal/Installation
Rear Bank (Bank 1)
1. Stabilizer Link - Remove
- Remove the right side stabilizer link.
2. Under-Floor TWC - Remove
3. Rear A/F Sensor (Sensor 1) - Remove
4. Rear Secondary HO2S (Sensor 2) - Remove
5. Rear WU-TWC Bracket - Remove

6. Rear Engine Mount Heat Shield - Remove

- Remove the rear engine mount heat shield (A).
7. Power Steering Heat Shield - Remove

- Remove the power steering heat shield (A).
8. Rear WU-TWC - Remove

- Remove the nuts (A).

- Turn the WU-TWC (A) as shown.

- Turn the WU-TWC (A), then take it out by turning it as shown.
9. WU-TWC Covers - Remove

10.All Removed Parts - Install

- Install the parts in the reverse order of removal with new gaskets and new self-locking nuts.
NOTE:
- Before installing the WU-TWC, install the WU-TWC covers.
- Tighten the WU-TWC bracket mounting bolts in the numbered sequence shown.
Was this page helpful?