Sunlight Sensor Test
In this manual: Sunlight Sensor Test
4steps
~24min
2/5difficulty
Done 0 of 4
Test
NOTE: Before testing the sensor, check for climate control DTCs.
1. Sunlight Sensor - Test

- Pull out the sunlight sensor (A).
- Turn the vehicle to the ON mode.
- Measure the voltage between (+) probe on terminal No. 2 and (-) probe on terminal No. 1 with the connector connected.
NOTE: The voltage readings will not change under the light of a flashlight or a fluorescent lamp.
Voltage should be:
- 3.56 V with no sunlight or the sensor covered up
- Less than 3.56 V with sunlight on the sensor (depending on sunlight intensity)
- If the voltage is not as specified, replace the sunlight sensor.
Sunshade Control Unit Input Test
NOTE:
- Before testing, check for DTCs. If any DTCs are indicated, troubleshoot those DTCs first.
- If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.
- If the sunshade works OK manually, but will not work in AUTO, or reverses frequently (obstacle detection), reset the sunshade before proceeding with the input test.
- Before testing, make sure the No. A2-4 (20 A) fuse in the under-hood fuse/relay box is OK.
- Before testing, make sure the No. C29 (7.5 A) fuse in the under-dash fuse/relay box is OK.
1. Disconnect the sunshade motor-control unit 10P connector.

2. Inspect the connector and socket terminals to be sure they are all making good contact:
- If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
- If the terminals are OK, go to step 3.
3. With the connector still disconnected, do the following input tests:
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, do the sunshade control unit resetting procedure.
NOTE: After replacing the sunshade motor-control unit, do the sunshade control unit resetting procedure.
| Cavity | Wire | Test condition | Test: Desired result | Possible cause if desired result is not obtained |
| 1 | RED | Under all conditions | Measure the voltage to ground: There should be battery voltage. |
|
| 10 | GRN | Vehicle in ON mode | Measure the voltage to ground: There should be battery voltage. |
|
| 4 | BLK | Vehicle in ON mode | Check for continuity to ground: There should be continuity. |
|
| 9 | GRN | Vehicle in ON mode, sunshade switch in CLOSE position | Check for continuity to ground: There should be continuity. |
|
| Vehicle in ON mode, sunshade switch released | Check for continuity to ground: There should be no continuity. |
|
||
| 7 | BRN | Vehicle in ON mode, sunshade switch in OPEN position | Check for continuity to ground: There should be continuity. |
|
| Vehicle in ON mode, sunshade switch released | Check for continuity to ground: There should be no continuity. |
|
||
| 14 | PNK | Vehicle in ON mode, sunshade switch in AUTO (OPEN) or AUTO (CLOSE) position | Check for continuity to ground: There should be continuity. |
|
| Vehicle in ON mode, or power mode ON, sunshade switch released | Check for continuity to ground: There should be no continuity. |
|
Was this page helpful?