Sunvisor Removal and Installation
In this manual: Sunvisor Removal and Installation
10steps
~60min
3/5difficulty
Done 0 of 10
Removal
1. Sunvisor - Remove

- Push the hook (A) with a flat-tip screwdriver through the hole in the front side of the bracket cover (B).
NOTE: Make sure the hook is unlocked.

- While pushing in the hook (A) with a flat-tip screwdriver, release the sunvisor (B) from the holder (C), and rotate the sunvisor backward 45 º.
NOTE: Make sure the hook slides into the bracket cover as you rotate the sunvisor.

- Disconnect the connector (A), and then remove the sunvisor (B).
NOTE: If the sunvisor cannot be removed, the hook has not rotated into the bracket cover. Repeat step 2 to rotate the hook.
2. Sunvisor Holder - Remove

- If necessary, turn the sunvisor holder (A) 45 º counterclockwise, and then remove it from the holder grommet (B).

- If necessary, remove the holder grommet (A).
Installation
1. Sunvisor - Check

- If the side curtain airbag has deployed, replace the sunvisor, along with the other parts listed for side curtain airbag deployment.
- If the side curtain airbag has not deployed, inspect the sunvisor for damage. A damaged sunvisor may cause the side curtain airbags to deploy improperly, possibly causing injury. Replace the sunvisor if it has any of the following damage:
- Any cracks in the sunvisor bracket (A)
- Any cracks in the sunvisor bracket cover (B)
- Any bends or cracks in the sunvisor shaft (C)
- Any cracks in the sunvisor base (D)
- Any cracks in the vanity mirror base (E)
- If the holder grommet is damaged or stress-whitened, replace the holder grommet and the holder as an assembly.

- Install the holder (A) into the holder grommet (B) by turning it 45 º clockwise.
- Install the holder and holder grommet as an assembly into the body by pushing it until the hooks snap into place securely.
3. Sunvisor - Install

- Connect the connector (A), and install the sunvisor (B).

Was this page helpful?